![]() In that case, try to release the ball valves (see the instructions and video above). As a result, the device will be unable to draw in or pump paint. If the device has not been properly cleaned, paint residue may get stuck in the ball valves of the plunger pump, or the nozzle may be blocked. In most cases, a cleaning problem is involved. Your request will be handled immediately. Please complete the warranty form and attach several photos that show the problem clearly. While a manufacturing defect is not a common occurrence, it is possible in this case. If a leakage occurs during use of the device for the first time, it could be that one of the seals is not properly joined. Please complete the warranty form at all times. Wagner can easily check the device in this regard, and act accordingly. Mechanical problems of course are covered immediately by the warranty. However, costs will be incurred, because cleaning-related defects are not covered by the warranty. If the problem is not solved, the device will need to be checked and cleaned professionally (please complete the warranty form). The components of the Titan model in the video are similar to those of Wagner's HEA Control Pro series. In that case, but also if this problem occurs when the device is used for the first time, try to release the ball valves of the pump by going through the steps described above and/or follow the instructions in this YouTube video. Have you thinned the paint sufficiently? And are you using the right nozzle for the job? If the water runs out of the outlet valve, the problem should be solved.Īirless device does not build up/no longer builds up any pressure Disconnect both the suction and return hoses, turn the device around, and fill the inlet valve with water.Disconnect the outlet valve and release the tiny ball, which is situated in the disconnected plug, and try priming again.Disconnect the suction and the return hoses, release the inlet ball valve that is situated at the bottom, and try priming again.Turn the switch to the SPRAY position, then back to the PRIME position, and try priming again.Press the red button on the side of the inlet valve until you feel a click, and try priming again.Take the following steps for the quickest solution: If the spray device does not suck up any paint when the selector switch is set to the PRIME position, the problem is usually a stuck plunger ball valve. White plug on the return hose broken offĪirless device does not suck up any paintįirstly, the device needs to be fully assembled as instructed in our website videos and the manual. ![]() Airless gun leaks at the front of the nozzle.Airless device does not build up/no longer builds up any pressure.Airless device does not suck up / draw in any paint. ![]() Please contact us if your current problem is not covered here. The following article covers the most frequently asked questions/problems, which will be answered, explained, and solved.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |